Antique Furniture Hardware

Dating antique furniture hardware

Antique Furniture Hardware

The Shakers are well

The Mercer library contains materials on both machine made screws and methods of cutting screws by hand. These new machine-made screws also resembled their ancestors in that they were still almost perfectly cylindrical and had a blunt tip. It is made of solid cast brass with a medium patina.

They attach with small brass pins

Each change is documented, most are patented. And the overall shape of the entire screw is cylindrical rather than tapered, as is the case in modern screws. The up and down saw leaves marks on wood that look like this. The screw on the right was machine made.

The introduction in of the completely machine-made gimlet screw, with a tapered shaft and a pointed tip, marked the beginning of the modern era in screw production. These include architectural artifact companies, antique hardware shops and some antique stores. Seldom was the cut placed exactly in the center. The circular saw leaves marks on wood that look like this.

Items made after are made using this new screw. They attach with small slotted screws which are included. The rough sawed lumber used in furniture construction was smoothed with either a hand held plane, or a planing machine. Furniture styles linger for years. There are many differences between a handmade and a machine-made screw.

The Dating of Old

The Shakers are well known for their simple but elegant furniture. They attach with small brass pins rather than screws. The Dating of Old Houses, a paper prepared by Dr. The circular saw was limited to cutting thin pieces of wood such as shingles, clapboards, and laths until the early s. The same problem arose while trying to affix a lock to the back side of a drawer.

Antique Furniture These situations are common occurrences for antique collectors, restorers and store owners. It would be completely covered by the screw. The shank of a handmade screw does not taper. Sloan of New York City invented the first machine to mass-produce this item.

For the first ten years of production, machine made screws were made with no slot in their head. No flea bites or cracks on either handle. Antique Furniture Reproduction Hardware In the past, finding original hardware for antique furniture has often been challenging and frustrating experience. The slot in the top was hand cut by a hacksaw. Because the new machine made screw was inexpensive, it was readily accepted by cabinetmakers.

When the smith had the length he thought was needed for the job, he simply cut or snipped the threaded shaft. In many cases the same smith who made the nails occasionally turned his craft to the making of screws and thereby left us with personal traces of the maker. These early latches were inlaid into cabinet doors rather than being attached to the surface, as were the later cast iron latches. Starting with the top of the screw, the head, evidence of handwork is abundant. But that solution would not work for securing the top on a chest of drawers or table top without either driving a nail through the top from above or clinching it on the top to hold it fast.